Before / After Calibration Data
Before and After Data can be provided if needed. Before Data is obtained by measurements that are made using NIST traceable standards when the unit arrives prior to calibration. Once the unit is calibrated and any necessary adjustments are made, after data is obtained using the same standards and test conditions as the before data. (Calibration not included in price).

IEEE Intf. Opt (factory installed)  
Provides IEEE-488 (standard digital interface for programmable instruments) through 24 pin rear panel connector on the 1865. Interface is factory installed when ordered with the unit.

Data/Prog Storage Opt(factory install)  
3 ½” disk drive (factory installed only) for storing test setup conditions and measured results on disk. Allows data to be transported to a PC for measurement analysis.-

Rear Panel Input Opt (factory install)  
Rear panel input option (+, -, ground & guard) for the 1865. Replaces the front panel connection.

Rack Mount Kit (for 1865)  
Rack mount kit contains dress panels and support hardware for adapting the 1865 to a standard 19” rack cabinet.

Shielded Lead Set (for 1865)  
An optional shield lead set for 1865, with three coaxial cables, each terminated with sheathed banana plugs which mate with removable alligator clips (included). One meter in length.

Component Test Fixture (for 1865)  
A fixture designed into a shielded case with hinged cover and interlock switch to reduce measurement errors and ensure operator safety. It includes a plug-in module for leaded components, another for surface mount devices, plus banana plug cables and alligator clips for connecting to a wide variety of components. A remote start and pass/fail indicators are located on the front panel.

IEEE Intf. Opt (1865, field retrofit)  
Provides IEEE-488 (standard digital interface for programmable instruments) through 24 pin rear panel connector on the 1880. Interface can be retrofit in the field when added to the unit and some later time.

Cable Set for 1867 (std w/unit)  
A cable set for 1867, with three coaxial cables, each terminated with alligator clips. One meter in length.

1868A Alligator Clip Lead Set (1868A Only)  
Lead Set for the 1868A, terminated w/ alligator clips for connection to the device under test. 1 1/2 meter in length.